1.
Securely mount the OPTI Club Strobeflower heads,
using the hanging brackets, in desired positions. It
is recommended that a safety chain is also fitted.
2.
Securely mount the Controller.
3.
Link the Controller to the Head(s) using the two
1
/
4
” stereo jack plugs, supplied with each unit,
linked with good quality stereo audio cable.
3a. For independent operation link each Head,
from one of the 4 CHANNELS on the
Controller, to CONTROL INPUT on
the Head.
3b. For identical operation link the first
Head to the Controller as above.
Then link that Head from CONTROL
THROUGH to CONTROL INPUT on
the next Head (as shown).
In this way a number of Heads can
be operated identically from each
CHANNEL, with each CHANNEL
operating independently.
Optikinetics Ltd.
38 Cromwell Road
Luton LU3 1DN England
Phone +44 (0)1582 4 1 1 413
Fax
+44 (0)1582 400613
Website
www.optikinetics.com
POWER RATING
Controller:
5 Watts maximum
Head:
100 Watts maximum.
MAINS CONNECTION
OPERATION
Operating Instructions
For optimum effect the OPTI Club Strobeflower Heads
should be used in conjunction with a 4 channel OPTI
Club Strobeflower Controller. Ask your dealer for a
demonstration.
FUSES
Controller:
T0.5A
(20mm x 5mmØ)
Head:
F2A
(20mm x 5mmØ)
OPERATING VOLTAGE
220-240V~ 50-60Hz
Both units come with a 2 metre, 3 core IEC lead with
5A fused UK mains plug. If another plug is required it
should be connected as follows:
BROWN = LIVE; BLUE = NEUTRAL;
GREEN/YELLOW = EARTH.
(220-240V~ Model)
Club Strobeflower
4.
To switch on, connect the IEC leads to each unit
and the mains supply. Each Head will operate
according to the the Controller settings.
5.
To disable (turn off) the Heads connected to the
Controller depress the BLACKOUT switch.
Beam Control
PARK
The beam pattern is stationary.
RUN
The beam pattern to rotates continuously
in one direction.
AUDIO
The beam pattern to periodically changes
to the beat of the music at the audio input.
Sequencing of Lamps
PATTERN
The lamps in the Heads on each of the 4
CHANNELS may be set to operate in four
preset sequences. The SPEED control
adjusts the rate of sequencing.
AUDIO
The stepping of the PATTERN, from one
state to next, is initiated by audio signal.
OVERRIDE
The lamp(s) of the corresponding channel
operates continuously with CHANNELS not
selected switched off.
Strobe Lamp Modes
SINGLE
Each step in the sequence produces a
single flash. SPEED adjusts the flash rate.
BURST
Each step in the sequence produces a
burst of flashes at maximum rate (16Hz).
SPEED adjusts the duration of each burst.
FULL
The lamp(s) operate continuously.
The four ‘LED’ OUTPUT lights indicate that the lamps
are on, off or flashing.