RS-485 Home-Run connection
Adding a Camera
From the Joystick
To add a camera to the joystick from using the OSD setup menu, follow the steps below.
1. Adding an IP camera
a. Press the [SETUP] button, and select option one (1) “Network Device” for IP
b. Fill out the Network Device fields to connect your camera.
Channel: Joystick Camera Address [CAM ID]. Options include 1 - 7.
Protocol: Options include VISCA (UDP), VISCA (TCP), Sony VISCA (UDP), ONVIF, & NDI.
IP: Camera IP address
Ctrl Port: Camera control port.
c. Once the above fields are filled, press the [ENTER] button to save the camera to the controller.
For PTZOptics and HuddleCamHD cameras, by default, the port assignments are 1259 for UDP control
and port 5678 for TCP control.
2. Adding a Serial camera
a. Press the [SETUP] button, and select option two (2) “Analog Device”
b. Fill out the Analog Device fields to connect your camera.
Channel: Joystick Camera Address. Options include: 1 - 7.
Protocol: Control protocol. Options include: VISCA, PELCO-D, & PELCO-P
Address: Camera control address. For best results, set Joystick & Camera control address to
the same value.
Baud Rate: Baud rate. Options include: 1200, 2400, 4800, 9600, 19200, 38400, & 115200. For
best results, use 9600.
c. Once the above fields are filled, press the [ENTER] button to save the camera to the controller.
14
Rev 1.2 2/21
