6212A Manual Version 14.56.docx
Page 22 of 58
“Roll Grinding” Automation will cause Lasercheck to provide streaming continuous measurements at a rate of
approximately 10 Ra values per second in response to input from the Windows software or trigger inputs to the
input port of the control box. Continuous measurements are stopped in response to input from the Windows
software or trigger inputs to the input port of the control box.
This Automation is used to perform automated measurements on large continuous surfaces so the entire
surface can be assessed as to its overall roughness and uniformity of roughness.
Set up for Individual Parts / Parts Inspection
Check “Parts Inspection”. Then select “OK”.
Parts Inspection Automation will cause Lasercheck to provide single measurements in response to input from
the Windows software program or trigger inputs to the input port of the control box.
This Automation is used to perform automated measurements on individual parts in high volume production.
Parts passing under Lasercheck will receive a single Ra measurement in response to any trigger mechanism.
Parts can be presented to Lasercheck on a conveyor or robot arm, or the Lasercheck sensor can be brought to
the part via robot.
Create New Lasercheck Windows Setup Files
Select Setup/New. A blank setup file will be presented.