6212A Manual Version 14.56.docx
Page 9 of 58
Software Setup
Lasercheck uses two different software packages. The control unit has software that initializes electronics,
controls the LCD screen, monitors the laser, reads detector signals, and calculates the alignment and surface
roughness. It also saves measurements in ASCII format files. This software comes
pre-installed
inside the control
unit. It is designed to auto load and auto execute whenever the “on / off” switch is turned on.
A CD or floppy disk with calibration & setup files plus the manual is provided. This software is installed on a
separate computer.
An optional Windows file transfer software program is provided on a separate CD. This software is installed on a
separate computer and uses the optional 110V or 220V Adaptor & RJ12 / Serial Interface Connecting Cable to
communicate with the control unit.
To Install Lasercheck Software
1)
Insert Lasercheck CD or disk into the appropriate drive.
2)
Click on the
Start
button. From the
Start
menu, choose
Run
.
3)
Click on
Browse
button.
4)
Select “a
ppropriate drive letter:
”
5)
Double click on
Lasercheck Model 6212A setup.exe.
6)
Finally, click on
Finish
button.