Chapter 1
•
Installing Software
50 Installing Software
Installing Software
You operate MGW x100 from a PC on your network. This PC will be
referred to as Management PC.
To operate MGW x100, you need to install the MGW EMS. Before installing
the MGW EMS, you must configure your PC for the network. If you replace
the Management PC, make sure that the new PC's network settings match the
previous PC's settings. If you choose different settings, the new Management
PC may not be able to communicate with MGW x100.
System Requirements
Pentium-III PC 500 MHz or higher with a 10/100BT network interface card
(NIC).
y
The MGW EMS currently supports the following operating systems:
y
Windows 2000 Professional with Service Pack 4
y
Windows XP Professional with Service Pack 1 or higher
y
128 MB RAM or more, depending on the number of MGW x100 units
you manage from the relevant PC.
y
200 MB free disk space or more.
y
CD-ROM drive (16
×
or faster).
Configuring the Management PC for the Network
Go to
My Network Places
and then to
Local Area Connection
.
y
Refer to the relevant Microsoft Windows documentation for further
instructions.
Installing MGW EMS
MGW EMS installs together with the current version of Java Runtime. To
install MGW EMS, follow the instructions below.
1.
If you are about to upgrade an existing system, use the previously
installed version of MGW EMS to upgrade the system software before
installing a new version of MGW x100.
2.
Close all programs and use the Add/Remove Programs wizard to uninstall
any earlier version of MGW EMS that you may have installed on your
PC.
3.
Insert the MGW x100 CD into your PC's CD ROM drive.
StockCheck.com