Chapter 1
•
Configuring MGW x100
48 Configuring MGW x100
Setting Network Parameters
Configuring MGW x100 for first use requires connecting a PC to Controller
A's COM1 port (front) and the use of HyperTerminal to access MGW x100.
If reconfiguring MGW x100's host controller name, use Telnet to access
MGW x100. To reconfigure TCP/IP settings, use the Platform page in MGW
EMS or the command line interface accessible via Telnet.
Network Interfaces and Default Settings
The table below lists available network interfaces and default settings. These
default settings apply to the interfaces of Controller A and B (when
applicable).
Name
Interface ID
Alias
IP Address
Subnet Mask
Front Gig1
1
gei5
115.100.100.100
255.255.0.0
Front Gig2
2
gei4
114.100.100.100
255.255.0.0
Rear A
* Available only in
MGSS5000
configuration
3 gei3
113.100.100.100
255.255.0.0
Rear B
4
gei2
112.100.100.100
255.255.0.0
PMC Ch A (front)
5
gei0
110.100.100.100
255.255.0.0
PMC Ch B (front)
* Available only in
MGSS5500
configuration
6 gei1
111.100.100.100
255.255.0.0
Table 7: Default settings for MGW x100's Network Interfaces
My Network Settings
Use the table below to make a note of your current network settings.
Name
Interface ID
Alias
IP Address
Subnet Mask
Front Gig1
1
gei5
Front Gig2
2
gei4
Rear A
3
gei3
Rear B
4
gei2
PMC Ch A (front)
5
gei0
PMC Ch B (front)
6
gei1
Table 8: My settings for MGW x100's Network Interfaces
StockCheck.com