Chapter 4
•
Replacing Hardware Components
184 Replacing Hardware Components
4.
Wait until the Hot Swap LED turns off before using this board.
Figure 59
:
Closing the Ejector/Injector Handles
When you replace the DVB Transcoder I/O board, the associated encoder service board
resets after the new board has been installed.
Make sure to cover all empty slots with slot covers.
Replacing the Host Controller's Flash Disk
You may replace the host controller’s flash disk only if you have been
instructed to do so by Optibase's customer support.
The host controllers are installed in the slots labeled
Control A
and
Control
B
(when applicable) and referred to as
Host A
and
Host B
respetively.
The flash disk is located in the host controller’s I/O board's upper left corner
and hosts the system software.
StockCheck.com