OPTi Solar 250 Operating Instructions Download Page 1

Optikinetics Ltd.

38 Cromwell Road  Luton  LU3 1DN  England
Phone

+44 (0)1582 411413

Fax

+44 (0)1582 400613

e-mail

[email protected]

Website

www.optikinetics.co.uk

* If the thermal cut out engages, allow to cool, check and clear air inlets and outlets, and switch projector back on.

1

OPERATING INSTRUCTIONS

POWER RATING

350W MAX

FUSES

Mains:

220-240V~ T2A/250V

 

(20 x 5mmØ)

110-120V~

T4A/250V

 

(20 x 5mmØ)

12V~ :

T4A/250V

OPERATING VOLTAGE

220-240V~  50-60Hz or 110-120V~  50-60Hz

ALL FAN INLET GRILLES MUST BE CLEAR WHEN THE
PROJECTOR IS IN USE.  NEVER OBSTRUCT.

Failure will cause the projector to overheat, may cause
damage, and the thermal cut-out to switch projector off*.

AN EFFECT MUST ALWAYS BE IN THE GATE OF THE
PROJECTOR WHEN IN USE.

Failure may cause the plastic parts of the focussing lens
to melt.

THE PROJECTOR MUST ONLY BE USED WITHIN 90

°

OF HORIZONTAL.

DO NOT TOUCH THE LAMP WITH BARE HANDS AND
NEVER TOUCH HOT LAMP.

Wear gloves or use a soft cloth or tissue.

DO NOT AT TEMPT TO SERVICE THE PROJECTOR
UNLESS YOU ARE QUALIFIED AND WORKING UNDER
THE DIRECTION OF THE MANUFACTURER.

The first step is to position the projector in a place from
which images can be projected onto the desired surface.
The projector must always be mounted using its bracket
and the air inlet grilles must be clear to allow airflow.

There are 4 methods of mounting:

2. Fixed with the hanging

bracket under the
projector onto an
immovable flat surface.

3. Mounted on top of a

flat surface by using
the hanging bracket as
an adjustable stand.

MOUNTING

A safety chain should be
fitted and secured, to an
immovable object, with a
maximum drop of 30cm (12").  All nuts, bolts, hanging
bracket knobs and other fixings must be securely tightened.

ADJUSTING THE BRACKET

1. Suspended from above

with its hanging bracket
firmly fixed to a strong
beam or Trilite truss.

PACKED BOX CONTENTS

Solar 250 Projector with 85mm Lens

2 metre IEC Lead

MAINS CONNECTION

4. Fixed with the hanging

bracket behind the
projector, at an angle,
bolted to an immovable
vertical surface.

IMPORTANT NOTES

Simply plug in the IEC lead
to the back of the projector
and   switc h   to   the   ON
position.

When setting up the projector, to
project the image where required,
it may be necessary to adjust
the hanging bracket.

1. Loosen central knobs on

both sides and rotate
the bracket or projector into
the desired position.

2. Tighten knobs securely.

Before use check the voltage
selector switch, on the back of
the projector, is set to the
same voltage as your local
mains supply.  If incorrect,
move to the correct voltage
position using a flat ended screw driver.

Switching On

Solar 250

Reviews: