Optex SC-U1, Operation Manual, Page: 74 / 92

74
Cleaning
Item Description Refer to
Shown below are the settings to activate the cleaning device using a relay output
("Cleaning output setting" P.47).
Cleaning
Interval (Relay)
Set the time interval between cleaning actions. P.76
Cleaning
Activation Set the time period for cleaning.
The last measurement value is retained (held) during cleaning. P.77
Post-cleaning
Standby Set the standby time after cleaning.
The measurement value is retained (held) during post-
cleaning standby. P.78
The settings work as shown below:
Cleaning
device
Measurement
value
Cleaning
Normal measurement Measurement value hold Normal measurement Measurement value hold
Cleaning interval (relay) Cleaning interval (relay)
Cleaning
activation
Post-cleaning
standby
Cleaning
activation
Post-cleaning
standby
Cleaning
The wiper and cleaning device can be manually activated. The cleaning device can be
activated only if the cleaning output has been set using relay output.
The measurement value of the target sensor is retained (held) during cleaning.
Select [MANUAL CLEANING] using ,
and press .
The cleaning device is activated and the display
returns to the measurement value display.
2
u
Manual Cleaning
On the sensor selection display, select a
sensor to set using
, and press .
The cleaning menu is displayed.
By selecting [ALL], all of the connected sensors can
be selected.
1
&OHDQLQJ
6HQVRU6HOHFW
㸯 S+ࠉࠉࠉ6(S+'
㸰7XUE7&'
㸱 '2'26
㸲
ࠉࠉࠉ$//
Output item Sensor model
Sensor channel
&OHDQLQJ
㸰 7XUE7&'
0$18$/&/($1,1*
&OHDQLQJ,QWHUYDOࠉࠉࠉPLQ
The sensor under cleaning shows "CLEAN" on the
measurement value display.
In addition, "C" is displayed in the sensor selection
display.
&OHDQLQJ
6HQVRU6HOHFW
㸯'2'26
& 㸰7XUE7&'
㸱S+6&'
ࠉࠉࠉ$//