46
Relay Setting
u
Maintenance output setting
1
5HOD\6HWWLQJ
&KDQQHO6HOHFW
2XWSXW,WHP7ULJ/HYHO
&+
2))
&+
㸱
'2+LJKPJ/
&+
㸱
'2/RZPJ/
&+
㸱
6HQV&DS
!
Output item
Sensor channel
Select [Output Item] using
,
and press
.
The current setting value is displayed.
2
5HOD\6HWWLQJ
&+
2XWSXW,WHP
2))
5HOD\6HWWLQJ
&+
2XWSXW,WHP
㸱0DLQW
Switch between pages using
,
select [Maint.] of a sensor channel
to set maintenance output using
,
and press
.
If output is unnecessary, select [OFF]
and press
.
Available display items depend on an installed sensor.
The set sensor channel and [Maint.] are displayed in
[Output Item].
3
5HOD\6HWWLQJ
&+
2XWSXW,WHP6HOHFW
㸱
0DLQW'26
㸱
6HQV&DS'26
㸱
&OHDQLQJ'26
6HOI&KHFN
Output
item
Sensor
model
Sensor channel
Set a maintenance timer for any cycle ("Maintenance Timer" P.70) to notify the user when
the set cycle has elapsed.
This is used for notification of sensor maintenance, replacement of consumables, and
overhaul timing.
Notifications can be checked by the relay output and the cloud server (when connected to the GW).
For more information about checking notifications on the cloud server, refer to the cloud
server's help.
Caution
To select the maintenance output as a relay output item, refer to "Maintenance Timer"
P.70 to configure the output cycle (days) before configuring the following setting.
After setting, the maintenance output can be selected as an output item of the relay.
On the channel selection display, switch
between pages using
, select a
channel to set using
, and press
.
The setting item selection menu is displayed and the
current setting of the selected channel is displayed.
