Optek PROFIBUS C4151, Instruction Manual, Page: 33 / 64

- 29 -
optek-Manual--1004-1010-02--ProfibusPA-US-2017-06-23
www.optek.com
Specifications
*** SET_ZERO_POINT (slot index 66)
With this parameter, the zero point for the corresponding measuring result can
be read in and set according to the software description.
Data type: Unsigned16 as single bits
High byte
Low byte
Upon writing the parameter, the low byte value can be any value from 0 to 255.
For reading the parameter, the following applies:
0x__00
→
High byte (see above);
Low byte operation is executed.
0x00FF
→
Operation was completed or standby position.
Example:
0x0300 = Read in zero point for measuring results M01 and M02.
0x0B00 = Read in zero point for measuring results M01, M02 and M04.
**** SET_PRODUCT (slot index 67)
With this parameter you can load a configured product in the converter.
Data type: Unsigned16
High byte
0x01
→
change to product 1
0x02
→
change to product 2
0x03
→
change to product 3
0x04
→
change to product 4
0x05
→
change to product 5
0x06
→
change to product 6
0x07
→
change to product 7
0x08
→
change to product 8
Low byte
Upon writing the parameter, the low byte value can be any value from 0 to 255.
For reading the parameter, the following applies:
0x__00
→
Operation product change is executed.
Standby position when writing the value 0x00 for the high byte.
0x__FF
→
Operation was completed or standby position.
BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
not used
zero point
M04
zero point
M03
zero point
M02
zero point
M01