OPT MACHINE VISION TECH.CO. LTD
ADD:8 JingSheng Road, JingXia ChangAn DongGuan China 523853
TEL: 0769-82716188 FAX: 0769-81606698
E-mail:
Website:Http://www.optmv.net
12
3
、
Operation Instructions
3.1 Wiring diagram
Figure 6: Wiring diagram
Step1: Connect the light source to controller (See Fig. 6).
Step2: If the external trigger control is necessary, connect the external trigger source to the controller (See Sect. 3.4).
Step3: Connect power source (AC100-240V) and turn on the power source. If the digital LED displays channel index then
the power is on.
If one needs to adjust the intensity through software, please connect the controller with
power off
to PC via RS232 or
Ethernet. Run our Demo program or one’s own program (i.e. SDK also available). The parameters for channels can still be
overridden manually via front panel while communicating through serial port or Ethernet (i.e., both host computer and the
controller can be individually adjusted). There is no need to switch the working mode. For the introduction of our Demo
program, please refer to Sect. 4 – “software operation instruction” and Sect.6 – “program manual”.
3.2 Turn on light source
step1: Turn off the controller.
step2: Connect the light source.
step3: Turn on the controller.
light source controller
PC
RS232/Ethernet port
light source interface
power supply input
trigger interface
接口
light source
trigger signal
AC100-240V
