Opt Lasers PLH3D 6W-XF, Start Manual

Page: 14 / 35

13
These settings directly relate to and dictate the laser Min & Max output value.
Firmware Settings: Make a Backup
Before we update the GRBL firmware
it’s a good idea to backup your settings.
A. Goto and Sign into: Easel ( http://easel.inventables.com )
B. In a new or existing Project,
■ Goto: Easel > Machine > Advanced
C. Click on "Machine Inspector"
D. Copy all the text in the "Settings" section and save to a text file in-case you need to reference
and restore settings. These setting are your GRBL Settings .
■
Example Settings
Settings Description
$0=10 Step pulse time, microseconds
$1=255 Step idle delay, milliseconds
$2=0 Step pulse invert, mask
$3=4 Step direction invert, mask
$4=0 Invert step enable pin, Boolean
$5=0 Invert limit pins, Boolean
$6=0 Invert probe pin, Boolean
$10=15 Status report options, mask
$11=0.020 Junction deviation, millimeters
$12=0.002 Arc tolerance, millimeters
$13=0 Report in inches, Boolean
$20=1 Soft limits enable, Boolean
$21=1 Hard limits enable, Boolean
$22=1 Homing cycle enable, Boolean
$23=3 Homing direction invert, mask
$24=25.000 Homing locate feed rate, mm/min
$25=800.000 Homing search seek rate, mm/min
$26=250 Homing switch debounce delay, milliseconds
$27=1.000 Homing switch pull-off distance, millimeters
$30=1000 Maximum spindle speed, RPM
$31=0 Minimum spindle speed, RPM
$32=0 Laser-mode enable, Boolean
$100=40.000 X-axis travel resolution, step/mm
$101=40.000 Y-axis travel resolution, step/mm
$102=188.976 Z-axis travel resolution, step/mm
$110=8000.000 X-axis maximum rate, mm/min
$111=8000.000 Y-axis maximum rate, mm/min
$112=500.000 Z-axis maximum rate, mm/min
$120=250.000 X-axis acceleration, mm/sec^2
$121=250.000 Y-axis acceleration, mm/sec^2
$122=25.000 Z-axis acceleration, mm/sec^2
$130=770.000 X-axis maximum travel, millimeters
$131=780.000 Y-axis maximum travel, millimeters
$132=94.000 Z-axis maximum travel, millimeters