LBL-2019-41-v4 OptoMonitor 3 IFU wTAVI_en Rev 2022-03
32
|
P a g e
8.
View button
Press this button to watch previously recorded measurements. Pressing this button switches the screen
to playback mode (3.10). If patient data has been entered, all previous recordings saved under this patient
ID will appear in the message window in the playback screen.
3.9
Structural procedure main Menu Screen Functions
Navigation through the instrument’s software menus is easily done in one single step using the direct
access buttons on the bottom of the touchscreen (menu window).
1.
Settings button
Pressing this button switches the screen to the SETTINGS (section 0) screen.
2.
Patient button
Access the patient information dialogue to enter patient name, ID, gender, date of birth, procedure date,
accession number, performing physician name, and study description. From the patient information
dialogue, you can access the DICOM list. See section 7.14.1 for more information.
NOTE: It is required to create the patient ID before each case to associate recordings to a
specific patient.
3.
AO Zero button
OptoMonitor 3 Aortic Zero.
See section 7.2.2 for more information.
4.
Equalization button
Equalize OpSens pressure wire (LV) pressure to Aortic (Ao) pressure. See section 7.5 for more information.
5.
Record button
Begin recording the pressures and measurements. When pressed, it changes to a STOP button, pressing
which will end the recording and switch the screen to playback mode (3.10). The number of beats the
calculations averages over (default=5) is set by the user in the SETTINGS screen (section 0). See section
7.10 for more information. The heart rate measurement is always measured on an average of 10 beats.