S E T U P M E N U O P T I O N S
30
Audio Setup Page
1.
SPDIF Output:
To set the bit stream type of the digital audio output. The options are:
•
RAW
– Passes the encoded multi-channel digital audio unaltered. Choose this setting if
your receiver/amplifier is capable of decoding Dolby Digital and DTS.
•
PCM
– Forces down-mixed 2-channel digital audio output. Choose this setting if your
receiver/amplifier only supports PCM audio.
2.
LPCM Out:
To set the maximum Linear PCM output frequency. The options are:
•
48K
– Supported by most equipment.
•
96K
– Better sound can result. Ensure that the receiver/amplifier can support it.
•
192K
– Better sound can result. Ensure that the receiver/amplifier can support it.
3.
PRO Logic II:
To configure the Dolby Pro Logic II function. Dolby Pro Logic II technology can
expand 2-channel source audio into full 5-channel surround sound.
•
Pro Logic II configuration is accessible only when down-mix is set to 5.1ch and SPDIF
output is set to Raw.
•
Press the SELECT button to enter the Pro Logic II setup page.
•
Press the LEFT ARROW button to exit the Pro Logic II setup page.
A.
Pro Logic II:
To turn on or off the Pro Logic II processing. The options are:
•
On
– Pro Logic II processing is always on
•
Off
– No Pro Logic II processing
•
Auto
– Pro Logic II processing is on only when Dolby Pro Logic II encoded content
is detected.
B.
Mode
: To set the processing mode of Pro Logic II. The options are:
•
Music
– Sound from all speakers arrive at the same time with no delay
•
Movie
– 10ms delay is added to the surround channels
•
Pro Logic
– Earlier version of Dolby Pro Logic processing
•
Auto
– Automatically selects processing mode based on content
C.
Panorama
: To turn on/off panorama mode. When turned on, front stereo audio is
extended to the surround channels for an enveloping effect.
D.
Dimension
: To increase or decrease the dimensional effect by adjusting the front to
rear balance. As the size number increases, the sound localization moves towards
forward from backward.
