Opengear MFC-8322-S, User Manual

Page: 33 / 72

MFC-8322-S and MFC-OG3-N User Manual (Iss. 01) MFC-OG3-N Series Setup • 4–3
Configuring the DIP Switches
This section briefly summarizes the DIP Switch settings on the card. Refer to Figure 4.1 for the
locations. Note that Figure 4.3 shows the DIP Switches in the ON position.
Figure 4.3 DIP Switches — Set to the ON Positions
SW1, SW2 — IP Address Setup
SW1 and SW2 are used in conjunction with the DashBoard menus to set the IP Address of the
card. Refer to Table 4.1 and the card labeling for DIP Switch positions. For more information on
configuring the network settings for your card, refer to the section “ Network Configuration ” on
page 2-4.
SW3 — Master Password Override
SW3 is used to override the Master Password. The Master Password feature limits the card to
support only authenticated connections. Refer to the section “ Using a Master Password ” on
page 2-7 for details.
• OFF — This is the recommended position. A user-specified Master Password is used.
The default password is
password
. It can be changed using DashBoard as outlined in the
section “ Using a Master Password ” on page 2-7.
• ON — This position is used to recover a lost Master Password. The user-specified
password is temporarily ignored, and the default value of
password
is used.
SW4
SW4 is not implemented at this time and should be left in the OFF position.
Table 4.1 SW1 and SW2 Positions
SW1
Position
SW2
Position
Controlled via
DashBoard
Descriptions
OFF OFF 
The card network settings can be set by the user
from the DashBoard
Network tab
a
. (default)
a. DHCP Mode is assumed until the user changes the settings in DashBoard.
OFF ON
The card network settings are automatically
assigned (DHCP Mode).
ON OFF
The card IP Address is set to 192.168.2.1 The card
Subnet Mask is set to 255.255.255.0.
ON ON
The card IP Address is set to 10.1.2.1. The card
Subnet Mask is set to 255.255.255.0.
1
3
4
2
O N