ACM5504-5-LA/LV/LR-I Quick Start (520059 -Rev 1.0)
Page 1
ACM5504-5-LA-I, ACM5504-5-LR-I
ACM5504-5-LV-I
Quick Start Guide
Thank you for purchasing the ACM5504-5-LA/LR/LV-I management gateway (referred to
herein as
ACM5504-5-L
). This Quick Start walks you through both installation and
configuration. For more details refer to the
User Manual
on the CDROM.
Step1 Check kit contents
ACM5504-5-L
device. E
xternal rack and DIN rail m
ount tabs.
External g
reen connector block and 7-band
4G LTE antenna.
UTP cables & straight (319014) & crossover (319015) DB9F-
RJ45S. Quick Start and CDROM. 12V DC power pack.
Step 2 Connect the hardware pieces
Attach rubber feet to base. Also attach the desired mounting tab and screw the
4G LTE antenna on to the main
Cell (M)
connector
Note:
If you have purchased a diversity antenna, screw it on to the
Cell (A)
connector.
If you have purchased a GPS antenna, screw it on to
GPS
Your carrier will provide a SIM card for activating you data plan. Unscrew the
SIM card access panel and
insert the SIM card in the bottom SIM slot
with contacts facing downward
and the notch to RHS. Then replace the SIM
card access panel. Refer User manual for multiple SIM installation
Note:
The
ACM5504-5-L
family works with 4G LTE carriers globally. The ACM5504-5-
LA-I works with AT&T’s 4G LTE 700 / HSPA service (USA). The ACM5504-5-LV-I
works with Verizon’s 4G LTE 700 / 3G EVDO service (USA). The ACM5504-5-LR-I
works with 4G LTE 800-2600 / HSPA+ carrier services globally
Connect the Ethernet
LAN
port to your network. Connect your management LAN
devices to the
ETHERNET 1-4
ports
Plug your serial console devices into
SERIAL 1-4
(all Cisco RJ45 pin-out).
Connect your USB devices to the two
USB
ports
.
Plug in the green screw
terminal block and attach external sensors and DIO
Note:
Refer ACM5500-I Addendum for RS422/485 and DIO details
Apply power
.
The
ACM5504-5-L
can now be powered externally by either:
connecting the provided external power pack to the
12VDC
barrel socket or
connecting an external 9 to 24 VAC source to the
12VDC
barrel socket or
conn9V to 30 VDC to
DC PWR
and
GND
on the green terminal block
