34918AG
29
NETWORK SECURITY
HTTP
The camera can send alarm messages to a specific Hypertext Transfer Protocol (HTTP) site when
motion is detected or when the sensor input is activated. You can assign alarm messages to up to
two HTTP sites.
IP Filtering
IP Filtering allows you limit access to your IP cameras by IP address. You can “Allow” or “Deny” a
specific IP address by adding it to the appropriate list. IP addresses on the “Allowed IP List” will be
able to access the IP camera. IP addresses on the “Deny IP List” will NOT be able to access the IP
camera.
IEEE 802.1XSEAP-TLS
This is a well supported security protocol commonly used by wireless vendors. This security method
requires a valid CA certification and key. When properly configured, all communication between the
client (usually a recorder) and the camera is encrypted.