background image

EVAL BOARD USER’S MANUAL

www.onsemi.com

©

 Semiconductor Components Industries, LLC, 2021

November, 2021 

 Rev. 4

1

Publication Order Number:

EVBUM2757/D

RSL15 Evaluation and Development Board User's
Manual

EVBUM2757/D

INTRODUCTION

Purpose

This manual provides information on the hardware configuration

and use of the RSL15 Evaluation and Development Board.

The Evaluation and Development Board (referred to as the EVB) is

designed to be used with the RSL15 Software development kit. It is
intended for evaluating the performance and capabilities of RSL15,
and for developing software applications for this device. The Software
Development Kit is available at 

www.onsemi.com/rsl15

.

Conventions

In this manual, component and pin names are shown in

a

CAPITALIZED MONOSPACE

 font.

Manual Organization

The RSL15 Evaluation & Development Board User Guide contains

the following sections:



Introduction” describes the purpose of this manual, explains how

the manual is organized, and provides a list of suggested reading for
more information.



Board Design and Overview

"

 provides an overview of the

Evaluation and Development Board as described in this manual.



Configuration

"

 provides detailed information about the Evaluation

and Development Board. This chapter contains information on the
following topics:

Automatic switching power supply

SEGGER

®

 J

Link

®

 on

board Debug Port

RF Outputs

General Purpose Input/Output (GPIO)

Test Points

Indicator LEDs

Further Reading

For any technical information not covered in this manual, refer to

the following documents:

The searchable HTML documentation

RSL15 Evaluation and Development Board Schematics

RSL15 Evaluation and Development Board 3D Model

The above documentation can be found at 

www.onsemi.com/rsl15

.

Figure 1. RSL15 Evaluation and

Development Board Overview

(Top Side)

(Bottom Side)

Summary of Contents for RSL15









Reviews: