Extrovert 4G LTE Modem for AT&T
NWK100
Setting up AT terminal applications for communication with NWK100
1.
Determine which COM port is being used by the NWK100. Open the Windows Device Manager (devmgmt.msc), then open the
Modems flyout and right click the u-blox Modem device. Right-click
Properties
. On the
Modem
tab, the COM device used is listed at the
top.
2.
Run the AT terminal application (e.g. puTTY), select
Serial
in the connection type and configure the port with these settings:
•
Data rate: 115200 b/s
•
Data bits: 8
•
Parity: N
•
Stop bits: 1
•
Flow control: HW
3.
Click Open.
4.
The AT terminal is ready to use. For the complete list of AT commands supported by the modules and their syntax, see the u-blox AT
Commands Manual.
US Office
Phone: +1 802 861 2300
Email: [email protected]
www.onlogic.com
EU Office
Phone: +31 85 2733760
Email: [email protected]
www.onlogic.com
5
