Onlogic HX310, Product Manual, Page: 41 / 43

25 PERp0 GND 26
27 GND 1.5V 28
29 GND SMB_CLK 30
31 PETn0 SMB_DATA 32
33 PETp0 GND 34
35 GND USB 2.0_D- 36
37 GND USB 2.0_D+ 38
39 3.3V GND 40
41 3.3V NC 42
43 GND NC 44
45 NC NC 46
47 NC 1.5V 48
49 NC GND 50
51 W_DISABLE2# 3.3V 52
6.6 - Appendix G: Safety Information
Do not open or modify the device. Modification of the device may void these certifications.
6.6.1 Safe use and installation instructions
1. Install the device securely. Be careful handling the device to prevent injury and do not drop.
2. Wall or ceiling mounting device requires use of a mounting plate or bracket. The plate or
bracket must be of metal construction and have a minimum thickness of 1mm.
3. Use M3x0.5mm Flat Head screws to attach mounting plate or mounting brackets to threaded
holes on bottom or rear of chassis. Screws should be a minimum length of 4mm. Add 1mm
of screw length for every mm of additional thickness of plate or bracket beyond 1.5mm.
4. Ambient operating temperature must be between 0 °C to 50 °C with a non-condensing relative
humidity of 10-90%.
5. The device can be stored at temperatures between -10 °C to 85 °C.
6. Keep the device away from liquids and flammable materials.
7. Do not clean the device with liquids. The chassis can be cleaned with a cloth.
8. Allow at least 2 inches of space around all sides of the device for proper cooling. If the device
is mounted to a vertical surface then recommended device orientation is so that heatsink fins
allow air to rise unobstructed. Alternative orientations may result in reduced operational
temperature range.
9. This device is intended for indoor operation only.
10. Use UL Listed external power supply with rated output 8-24Vdc
11. Install the device only with shielded network cables.
12. The installer should be experienced in aftermarket installation and familiar with general
practices for installing electronics devices in vehicles.
13. Service and repair of the device must be done by qualified service personnel. This includes,
but is not limited to, replacement of the CMOS battery. Replacement CMOS battery must be
of the same type as the original.
14. Proper disposal of CMOS battery must comply with local governance.
41