Onlogic HX310, Product Manual, Page: 15 / 43

DisplayPort 1, 2, & 3
Helix utilizes Intel’s Integrated Gen 11 processor graphics that power the onboard DisplayPorts. This
means resolutions up to 4096x2160 @ 60Hz are supported on all three outputs simultaneously. All
ports support Multi-Stream Transport (MST).
An additional CEC module can be included to add CEC (Consumer Electronics Control) functionality
on DisplayPort 2 & 3. This feature is not supported on the DisplayPort 1 connector.
LAN1 - MaxLinear GPY115 PHY
Helix supports up to 1Gbps link speeds over standard shielded CAT5e or CAT6 cables. This is done
using the Integrated MAC and the MaxLinear GPY115 PHY. The connector is the industry standard
RJ45 connector. The LAN link state and activity is shown by the two LEDs enclosed in the port. The
description is included below.
LAN2 - MaxLinear GPY115 PHY
The second LAN Port on Helix supports up to 1Gbps link speeds over standard shielded CAT5e or
CAT6 cables. The connector is the industry standard RJ45 connector. The LAN link state and activity
is shown by the two LEDs enclosed in the port. The description is included below. The second LAN
port is available only with the Pentium J6426 CPU option.
LED State Function
LED1
Blinking
Green
1Gb/s
activity
LED2
Blinking
Orange
100 Mb/s
activity
Blinking
Green
10 Mb/s
activity
LAN activity light description
USB 3.2
The dual stack USB 3.2 ports on the rear panel are USB 3.2 Gen 2 ports, capable of linking at 10Gb/s
transfer rates.
15