158
≫
≫
≫
≫
≫
≫
2. Speaker
1. Configuration
Change the settings of connection environment of the speakers.
Setting Item
Default Value
Setting Details
Speaker
Channels
7.1.4 ch
Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch", "6.1 ch",
"7.1 ch", "2.1.2 ch", "3.1.2 ch", "4.1.2 ch",
"5.1.2 ch", "6.1.2 ch", "7.1.2 ch", "4.1.4 ch",
"5.1.4 ch", "6.1.4 ch" or "7.1.4 ch" to suit the
number of speaker channels connected.
Subwoofer
2ch
Set the PRE OUT SUBWOOFER jacks which
output audio signals.
"2ch": Both the PRE OUT SUBWOOFER 1 jacks
and the PRE OUT SUBWOOFER 2 jacks output
audio signals.
"1ch": Only the PRE OUT SUBWOOFER 1 jacks
output audio signals.
"No": Neither the PRE OUT SUBWOOFER 1 jacks
nor the PRE OUT SUBWOOFER 2 jacks output
audio signals.
Setting Item
Default Value
Setting Details
Height 1 Speaker Top Front
Set the speaker type if height speakers are
connected to the HEIGHT 1 terminals. Select "Top
Middle", "Top Rear", "Rear High", "Dolby Speaker
(Front)", "Dolby Speaker (Surr)", "Dolby Speaker
(Back)", "Front High" or "Top Front" according to
the type and layout of the connected speakers.
• This setting cannot be selected under any of
following conditions. Set the height speakers
type to "Height 2 Speaker".
– When one set of height speakers are being
used and "Bi-Amp" is set to "Yes"
– When "Speaker Channels" is set to "2.1.2 ch",
"3.1.2 ch", "4.1.2 ch " or "5.1.2 ch", and "Zone
Speaker" is set to "Zone 2/ Zone 3"
• When two sets of height speakers are being
used, "Top Rear", "Rear High", "Dolby Speaker
(Surr)", and "Dolby Speaker (Back)" cannot be
selected.
• "Dolby Speaker (Surr)" and "Dolby Speaker
(Back)" can only be selected when surround
speakers or surround back speakers are being
used, respectively. You can check speakers that
you are using on the figure displayed in "Speaker
Channels".
• If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.
