![background image](http://html1.mh-extra.com/html/onkyo/htp-390/htp-390_manual_1637000001.webp)
E
n
Enjoying Home Theater
The Home Theater means that you can enjoy surround sound with a real sense of movement in your own home — just like being in
a movie theater or concert hall.
Connecting the Speakers
Corner
position
1/3 of wall
position
Center speaker
(SKC-390N/SKC-390C)
Position it close to your TV (preferably
on top) facing forward at about ear
level, or at the same height as the
front left and right speakers.
Front left and right speakers (SKF-390N/SKF-390)
They should be positioned facing the listener at about ear level,
and equally spaced from the TV. Angle them inward slightly so
as to create a triangle, with the listener at the apex.
Surround left and right speakers (SKR-390)
Position them at the sides of the listener, or
slightly behind, about 60 to 100 cm (2 to 3 feet)
above ear level. Ideally they should be equally
spaced from the listener.
Subwoofer (SKW-390)
The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects) chan-
nel and bass from the satellite speakers when a crossover is specified. The volume
and quality of the bass output from your subwoofer will depend on its position, the
shape of your listening room, and your listening position. In general, a good bass
sound can be obtained by installing the subwoofer in a front corner, or at one-third
the way along the front wall, as shown.
Red
White
Blue
Green
Front right
speaker
Center speaker
Gray
Front left
speaker
Surround right
speaker
Surround left
speaker
Subwoofer
Speaker Connection
Precautions
Read the following before connecting your
speakers:
• Turn off your receiver before making any
connections.
• Pay close attention to speaker
wiring polarity. Connect posi-
tive (+) terminals to only pos-
itive (+) terminals, and
negative (–) terminals to only negative (–)
terminals. If the speakers are wired incor-
rectly, the sound will be out of phase and
will sound unnatural.
• Be careful not to short the positive and
negative wires. Doing so may damage
your amp.
Purple
Specificattions
■
Passive Subwoofer (SKW-390)
■
Front Speakers
■
Center Speaker
■
Surround Speakers (SKR-390)
Specifications and appearance are subject to change without
prior notice.
Note
For non-magnetic shielded speakers:
Try moving the speakers away from your TV or monitor. If discoloration should occur, turn off your TV or monitor, wait 15 to 30
minutes, and then turn it back on again. This normally activates the degaussing function, which neutralizes the magnetic field,
thereby removing any discoloration effects.
Type
Bass-reflex type Passive subwoofer
Impedance
6
Ω
Maximum input power
130 W
Sensitivity
83 dB/W/m
Frequency response
30 Hz to 150 Hz
Cabinet capacity
25 L (0.88 cubic feet)
Dimensions (W
×
H
×
D)
295 mm
×
345 mm
×
368 mm
(11-5/8"
×
13-9/16"
×
14-1/2")
(incl. projection)
Weight
6.4 kg (14.1 lbs.)
Drivers unit
20 cm (8") Cone
×
1
Terminal
Spring type color coded
Other
Non-magnetic shielding
SKF-390N (North American and Brazilian)
Type
Full Range Bass-reflex
Impedance
6
Ω
Maximum input power
120 W
Sensitivity
81 dB/W/m
Frequency response
80 Hz to 20 kHz
Cabinet capacity
1.4 L (0.05 cubic feet)
Dimensions (W
×
H
×
D)
101 mm × 231 mm × 119 mm
(4"
×
9-1/8"
×
4-11/16")
(incl. grille and projection)
Weight
0.8 kg (1.8 lbs)
Drivers unit
8 cm (3-1/4") Cone
×
1
Terminal
Spring type color coded
Keyhole slot
Available
Grille
Fixed
Other
Non-magnetic shielding
SKF-390 (Asian)
Type
Full Range Bass-reflex
Impedance
6
Ω
Maximum input power
120 W
Sensitivity
82 dB/W/m
Frequency response
80 Hz to 20 kHz
Cabinet capacity
1.4 L (0.05 cubic feet)
Dimensions (W
×
H
×
D)
101 mm × 231 mm × 119 mm
(4"
×
9-1/8"
×
4-11/16")
(incl. grille and projection)
Weight
0.9 kg (2.0 lbs)
Drivers unit
8 cm (3-1/4") Cone
×
1
Terminal
Spring type color coded
Keyhole slot
Available
Grille
Fixed
Other
Magnetic shielding
SKC-390N (North American and Brazilian)
Type
Full Range Bass-reflex
Impedance
6
Ω
Maximum input power
120 W
Sensitivity
81 dB/W/m
Frequency response
80 Hz to 20 kHz
Cabinet capacity
1.4 L (0.05 cubic feet)
Dimensions (W
×
H
×
D)
230 mm
×
103 mm
×
115 mm
(9-1/16"
×
4-1/16"
×
4-1/2")
(incl. grille and projection)
Weight
0.8 kg (1.8 lbs)
Drivers unit
8 cm (3-1/4") Cone
×
1
Terminal
Spring type color coded
Keyhole slot
Available
Grille
Fixed
Other
Non-magnetic shielding
SKC-390C (Asian)
Type
Full Range Closed Box
Impedance
6
Ω
Maximum input power
120 W
Sensitivity
84 dB/W/m
Frequency response
80 Hz to 20 kHz
Cabinet capacity
1.4 L (0.05 cubic feet)
Dimensions (W
×
H
×
D)
230 mm
×
103 mm
×
115 mm
(9-1/16"
×
4-1/16"
×
4-1/2")
(incl. grille and projection)
Weight
1.3 kg (2.9 lbs)
Drivers unit
8 cm (3-1/4") Cone
×
2
Terminal
Spring type color coded
Keyhole slot
Available
Grille
Fixed
Other
Magnetic shielding
Type
Full Range Bass-reflex
Impedance
6
Ω
Maximum input power
120 W
Sensitivity
80 dB/W/m
Frequency response
80 Hz to 20 kHz
Cabinet capacity
1.0 L (0.035 cubic feet)
Dimensions (W
×
H
×
D)
101 mm
×
161 mm
×
115 mm
(4"
×
6-5/16"
×
4-1/2")
(incl. grille and projection)
Weight
0.7 kg (1.5 lbs.)
Drivers unit
8 cm (3-1/4") Cone
×
1
Terminal
Spring type color coded
Keyhole slot
Available
Grille
Fixed
Other
Non-magnetic shielding
Using the Floor Pads for Subwoofer
If the subwoofer is placed on a hard
floor (wood, vinyl, tile, etc.) and
playback is very loud, the sub-
woofer’s feet may damage the floor-
ing. To prevent this, place the
supplied pads underneath the sub-
woofer’s feet. The pads also provide
a stable base for the subwoofer.
Subwoofer (SKW-390)
Subwoofer
Speaker cable 3.0 m
(10 ft.)
4 floor pads*
(Purple)
Speaker terminals
Pad
5.1ch Home Theater Speaker Package
HTP-390
Y1012-1
* 2 9 4 0 0 6 2 9 *
SN 29400629
(C) Copyright 2010 ONKYO SOUND & VISION CORPORATION Japan. All rights reserved.
Wall Mounting
Using the Rubber Stoppers for a More Stable Platform
Front speaker (SKF-390N/SKF-390)
Center speaker (SKC-390N/SKC-390C)
Surround speaker (SKR-390)
Front speakers
Speaker cables 3.5 m
(11 ft.)
Center speaker
Speaker cable 3.0 m (10 ft.)
Surround speakers
Speaker cables 8.0 m (26 ft.)
SKF-390N (North American and Brazilian)
SKF-390 (Asian)
SKC-390N (North American and Brazilian)
SKC-390C (Asian)
*
Configuration of the rubber stoppers may be different from the figure,
such as being 2 sheets instead of 1 sheet, but the total number will be
same.
12 thick rubber stoppers
*
16 thin rubber stoppers
*
Caution
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
To mount the front/surround speakers vertically, use the keyhole slot
shown to hang each speaker on a screw that’s securely screwed into the
wall.
To mount the center speaker horizontally,
use the two keyhole slots shown to hang the
speaker on two screws that are securely
screwed into the wall.
Caution
• A mounting screw’s ability to support a
speaker depends on how well it’s anchored
to the wall. If you have hollow walls,
screw each mounting screw into a stud. If
there are no studs, or the walls are solid,
use suitable wall anchors. Use screws with
a head diameter of 9 mm (5/16") or less
and a shank diameter of 4 mm (1/8") or
less. With hollow walls, use a cable/pipe detector to check for
any power cables or water pipes before making any holes.
• Leave a gap of between 5 mm (3/16") and 10 mm
(7/16") between the wall and the base of the screw head,
as shown. (We recommend that you consult a home instal-
lation professional.)
We recommend using the supplied rubber stoppers to
achieve the best possible sound from your speakers. The
rubber stoppers prevent the speakers from moving, provid-
ing a more stable platform. Use thick stoppers for the cen-
ter speaker, and thin stoppers for the other speakers.
(White)
(Red)
(Green)
(Blue)
(Gray)
Speaker
terminals
Keyhole
slot
SKF-390N/SKF-390
Speaker terminals
Keyhole slots
SKC-390N/
SKC-390C
Speaker termi-
nals
Keyhole slot
SKR-390
Keyhole slot for
wall mounting
Thick rubber
stoppers
SKF-390N/SKF-390
Keyhole slots for wall mounting
183 mm (7-3/16")
Thick rubber
stoppers
Keyhole slot for
wall mounting
Thick rubber
stoppers
SKR-390
Wall
5 to 10 mm
(3/16" to 7/16")
Thin rubber stoppers
Bottom of the
SKR-390
Bottom of the
SKF-390N/
SKF-390
Bottom of the
SKC-390N/SKC-390C
50 mm
(1-15/16")
12 mm (1/2")
Thick rubber stoppers
HTP-390_EnFr_101221.book Page 1 Tuesday, December 21, 2010 3:03 PM