Onkyo HT-R648, Instruction Manual

Page: 56 / 76

56
En
Controlling Other Components
You can use the AV receiver’s remote controller to
control your other AV components. This section explains
how to enter the remote control code (with the default
underlined) for a component that you want to control:
DVD, TV, CD, etc.
The following
REMOTE MODE
are preprogrammed
with remote control codes for controlling the components
listed. You do not need to enter a remote control code to
control these components.
For details on controlling these components, see the pages
indicated.
You’ll need to enter a code for each component that you
want to control.
Note
• The remote control codes provided are correct at the time of
printing, but are subject to change.
Onkyo components that are connected via
u
are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
Controlling Onkyo components without
u
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via
u , use the
following remote control codes:
`
30627 :
Onkyo DVD player without u
`
71817 :
Onkyo CD player without
u
`
32900/33100/33500 :
Onkyo Blu-ray Disc player
`
32901/33104/33504 :
Onkyo HD DVD player
`
70868 :
Onkyo MD recorder without
u
`
71323 :
Onkyo CD recorder without
u
`
82990 :
Onkyo Dock without u
Preprogrammed Remote Control
Codes
BD/DVD Onkyo Blu-ray Disc player (
➔
page 57 )
TV/CD Onkyo CD player (
➔
page 57 )
PORT Onkyo Universal Port Option (
➔
page 54 )
Entering Remote Control Codes
1
Look up the appropriate remote control code in the
separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down the
REMOTE MODE
to
which you want to assign a code, press and hold
down
DISPLAY
until the remote indicator lights
(about 3 seconds).
Note
• Remote control codes cannot be entered for RECEIVER
and ZONE 2 .
• Only TV remote control codes can be entered for TV .
• Apart from RECEIVER , TV , and ZONE 2 , remote control
codes from any category can be entered for REMOTE
MODE . However, these buttons also work as input selector
buttons (
➔
page 20 ), so choose a REMOTE MODE that
corresponds with the input to which you connect your
component. For example, if you connect your CD player to
the CD input, choose
TV/CD when entering its remote
control code.
3
Within 30 seconds, use the number buttons to enter
the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered successfully,
the remote indicator will flash once slowly.
Remote Control Codes for Onkyo
Components Connected via
u
1
Make sure the Onkyo component is connected with
an
u
cable and an analog audio cable (RCA).
See “Connecting Onkyo
u
Components” for details
(
➔
page 17 ).
2
Enter the appropriate remote control code for
REMOTE MODE , by referring to the previous
section.
`
42157 :
Onkyo cassette tape deck with
u
`
81993 :
Onkyo Dock with u
3
Press REMOTE MODE , point the remote
controller at the AV receiver, and operate the
component.