Onfloor Striker 2010, Operator'S Manual

Page: 14 / 76

OPERATION
12
The machine is equipped with a circuit breaker.
This breaker is easily reset after preventing
electrical damage during an overload.
The circuit breaker protects the brush motor
It is located on the control panel. If breaker trips,
determine cause, let motor cool, then reset.
The machine is equipped with two fuses. The
fuses are attached to wires hanging in the lower
area inside the control console:
The powered model has a 30A main fuse and a 25
amp vacuum motor fuse.
The brush assist model has a 5A main fuse and a
25A vacuum motor fuse.
CIRCUIT BREAKER / FUSES
Contact your dealer or Authorized Service
Center for Machine repairs.
DRAINING RECOVERY TANK
1. To drain remaining water from the solution tank,
remove solution tank level hose from the barbed
fitting.
2. To clean out the solution tank, remove the clean
out cap at the rear of the machine and rinse the
tank through the openning in the front of the
recovery tank.
3. To rinse out the solution tank, remove the clean
out cap at the rear of the machine and rinse fill
port under the recovery tank.