38
Chapter 3:
Using Easy Print Mode
O’Neil Programming Language Reference Manual
Configure Label Parameters {CLP:nn}
Values/
Format
Original
MF2, MF3,
2t, 4t
Radio
Ready
2t, 3l, 4t
{
A left bracket begins the command set.
CLP:
nn
Use the following information to specify
the parameters:
B:
nn
- Back up distance at the
beginning of every Easy Print job.
nn
in dotlines
(.005 inches)
Deafult is 0 (off)
X
D:
nn
- Distance to advance after the
QMark (or gap) is detected before
stopping at the end of the label.
Note
: Setting this parameter enables
automatic QMark alignment when the
feed button is pressed.
nn
in dotlines
(.005 inches)
Default is 0 (off)
X
M:
nn
- Maximum distance to advance
stock if QMark or gap is not detected
nn in dotlines
(.005 inches)
Default is 2400
or 12 inches
X
P:
n
- Presenter should be used (holds
off subsequent print jobs until printed
image is removed). Requires
re-threading of label stock.
n=Y: Presenter
is on
n=N: Presenter
is off (default is
off)
X
(LP3 only)
S:
n
- Sensor used for paper out.
T = Top or Front
sensor
B = Bottom or
back sensor
(default is back)
X
(LP3 only)
T:
n
- Type of paper used by default.
Note
: Default is P for Plain Paper. If B is
selected, the paper out sensor moves
to T. If T is selected, the paper out
sensor moves to B. This can be
overridden by including the S
parameter
after
the T parameter in the
CLP command.
P
= Plain Paper
G
= Interlabel
Gap
T
= Top/Front
Qmark
B
= Bottom/
Back Qmark
U:
nnn
- Specifies how long the printer
remains awake if a printed image is left
in the presenter. This can be used to
extend the normal timeout - the printer
uses the longer of the system timeout
or the Under Presenter timeout
nnn
in seconds
(default is 0)
X
Summary of Contents for microFlash2
Page 3: ......
