30
Chapter 3:
Using Easy Print Mode
O’Neil Programming Language Reference Manual
Configure Default Protocol {CL:nnn}
Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{
A left bracket begins the command set.
CL:nnn
Changes the default protocol to one of
the following:
ESC :Line Printer Mode (default)
EZ : Easy Print Mode
EMC1 : Custom 1
EMC2 : Custom 2
EMC3 : Custom 3
EMP1 : PGL
EMZ1 : CPCL
EMZ2 : Cog
EMZ3 : ZPL
X
X
}
A right bracket ends the command set.
Set Test Print {TP:n}
Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{
A left bracket begins the command set.
TP:n
Sets test print.
n = 0 : Normal self test (default)
n = 1 : Special MAC address label
Note: When
n
is not zero, a special self-
test label is printed. After a special label
is printed, performing another self-test
within 10 seconds prints the normal self
test.
X
X
}
A right bracket ends the command set.
Configure Paper Out Beep {CU:n}
Original
MF2, MF3, 2t, 4t
Radio Ready
2t, 3l, 4t
{
A left bracket begins the command set.
CU:n
Sets the printer to continuously remind
the user that the paper needs to be
changed. Beep repetitions stop when
printer goes to sleep. Configures the
paper out beep as follows:
n = 0 : One Beep (default)
n = 1 : Five Beeps
n = 2 : Five Beeps repeated every 15s
n = 3 : Five Beeps repeated every 30s
n = 4 : Five Beeps repeated every 60s
X
X
}
A right bracket ends the command set.
Summary of Contents for microFlash2
Page 3: ......
