Package Contents
Camera components
K. M32 Conduit Locking nut
J. M12 to M20 adapter
Accessories
Supplied Parts
• A.
Front Cover
• B.
EVO-180 Camera module
• C.
Rear Enclosure
• D.
Mounting Bracket
• E.
Back cover
• F.
Sun-shields x 2
• G.
Side Conduit plug x 2 (fitted)
• H.
M32 - M20 Adapter (fitted)
• I.
M20 Conduit Port plug (fitted)
• J.
M12 - M20 Adapter
• K.
M32 Conduit Locking Nut
• L.
Drilling template
• M.
Screwdriver and security bit
• N.
12 pin I/O 12V Connector
• O.
Quick Start Guide
• P.
Infil black cover (fitted)
• Q.
Reverse mount screws
Option A. Surface Mounting
• Remove the back cover by
unscrewing the M20 plug
and M32 to M20 adapter.
• Refit them into the unused
port on the top.
• Drill mounting holes.
• Drill hole for cable entry within
the shaded areas.
The Evolution 180 Outdoor camera is designed for installation on flat surfaces or
pendants.
The camera is supplied with a mount bracket that is used to fix the camera to
a surface or a pendant.
Note:
You will need 4 appropriate fixing screws for surface mounting.
• Route an unterminated
network cable through the
pendant mount hole.
• Screw the mount assembly
onto the pendant and lock
with the locking nut (
K
).
• Leave a minimum of 30cm of
ethernet cable protruding.
• Route an unterminated
network cable through the
bracket. Leave a minimum of
60cm of cable protruding.
• M12 Conduit ports are
available for side cable entry
via the M12 to M20 adapter
(
J
).
• Pass the network cable
through the P-clip and cable
gland.
• Pull 30cm of cable through
and then tighten the nut fully
as shown.
• Insert “Infil”(
P
) only if
the camera is to be set
horizontal. If the camera is
to be tilted, the infil is not
necessary.
• Remove the sun shields.
• Undo the locking screw
(turning it anti-clockwise).
• Remove the front cover but
leave the protective film on
the dome.
• Unscrew the 4 security
screws.
• Insert the SD card into the camera module (optional).
• Plug the RJ45 into the camera module.
• Tighten up 4 security screws that fix the camera module to the rear enclosure.
• Take off the protective plastic film off the dome.
• With care, replace the front cover and tighten up the locking screw.
• Replace the sun shields.
• Both camera LEDs should be green when the camera is booted with an ethernet
connection.
• Loosen the pivot screws from
the outside.
• Hook the rear enclosure on
the mounting bracket.
• Pull the rear enclosure down
fully.
• Terminate the cable with a
RJ45.
• Aim the rear enclosure at the
required angle for the camera
• If camera is tilted, remove
infil (
P
).
• Tighten the pivot screws and
then the locking grub screws.
Note:
For 12V power supply installation, please refer to the User manual for more information.
Option B. Pendant Mounting
Completing the Installation
Prepare the bracket for surface mounting
1.1
1.2
1.4
2.2
1.3
2.1
2.3
2.4
Route a cable through bracket
Mount bracket on pendant
Drill holes
Connect and fix camera module in enclosure
Route cable into rear enclosure
Remove the rear enclosure
Hook in rear enclosure and set mount angle
