AP0100AT2L00XUGAH
−
GEVB
CONFIDENTIAL AND PROPRIETARY
NOT FOR PUBLIC RELEASE
www.onsemi.com
3
Jumper Pin Location
The jumpers on headboards start with Pin 1 on the
leftmost side of the pin. Grouped jumpers increase in pin
size with each jumper added.
Figure 5. Pin Locations for a Single Jumper. Pin 1 is Located at the Leftmost Side
and Increases as it Moves to the Right
Pins 1
−
4
Pin 1
Figure 6. Pin Locations and Assignments of Grouped Jumpers.
Pin 1 is Located at the Top-Left Corner and Increases in a Zigzag Fashion Shown in the Picture
Pins 1 and 2
Pin 1
Pins 3 and 4
Pins 5 and 6
Pins 7 and 8
Pins 9 and 10
Jumper/Header Functions & Default Positions
Table 1. JUMPERS AND HEADERS
Jumper/Header No.
Jumper/Header Name
Pins
Description
P3
TRST_BAR
Open
OTPM Programming Voltage Not Supplied
2
−
3 (Default)
Set to Normal Mode
P4
SADDR
Open
Set to Test Mode
Open
Analog Test 1 Header
P5
SPI_SDI_BAR
1
−
2 (Default)
GND; AP0100 in Host Mode
Open
SPI_SDI_SEL; AP0100 in Flash Mode
P6
STANDBY
2
−
3 (Default)
Active Mode
1
−
2
Standby Mode
Open
I
2
C IO Expander Control
P7
SPI Memory Selection
2
−
3 (Default)
EEPROM Disable/Flash Enable
Open
Flash Disable/EEPROM Enable
P8
GPIO_5
Open (Default)
Serial IO Expander Control
1
−
2
Set to Normal
2
−
3
Set to Vertical Flip
P9
+AVDD
Closed (Default)
Connects to On-Board Reg1V8, Internal
Regulator Use
Open
Disconnects from On-Board Reg1V8, External
Regulator Use
P10
+SVDDIO
3
−
5
Select Demo 3 Baseboard Clock
2
−
4
Select Slave Clock (for Slave Sensor in Multi-Camera
Mode)
Downloaded from
Downloaded from
Downloaded from
