9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB
7
Danger:
In case of faults it is possible that the desktop moves a bit during every start-up attempt
before the safety shut-down initiates. During this process, always watch out for the possible danger
of being crushed.
Danger:
The optionally available corrosion protection is not activated during any reset process
(Section 5). During this process, always watch out for the possible danger of being crushed.
Attention:
If the product is visibly damaged, never assembly it or continue to use it!
1.4.2 Before installation, deinstallation or troubleshooting
•
Stop the sit/stand desk.
Note:
Switch off the power supply and pull out the power cable!
•
Remove all weights from the sit/stand desk.
•
Only trained electricians are permitted to open or replace electrical equipment.
•
Do
not
operate the desk in moist rooms such as bathrooms.
•
Never
use the desk in explosive environments.
1.4.3 Before initial operation
•
Make sure the desk is assembled in accordance with these instructions.
•
Make sure that the side panels are perpendicular to the table top, after the desk is set up.
•
Check to see if the operating voltage of the desk matches the local power supply.
(See rating plate on the controller, standard = 230V)
•
Connect the plug connectors from the actuator and the side panels to the controller.
•
Connect the mains cable to the controller.
1.4.4 During operation
•
If the drives or the controller make any unusual noises or cause any unusual odours during operation,
interrupt the power supply.
•
Make sure that the cables are not damaged.
•
When operating the sit/stand desk, make sure that no objects or body parts can get trapped.
•
All moving parts of the desk base must have at least 25 mm clearance to the adjoining components.
1.4.5 Important information for resellers
We consider resellers companies that purchase the FREE.STAND sit/stand desk from Oelschläger
Metalltechnik
GmbH and that resell it as their own product after adding a table surface.
