9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB
15
5.2.3 Connect the power supply cable /mains cable
Attention:
Before you plug in the power supply cable, check again
•
to see if the mains voltage matches the rating plate of your controller
•
to see if all components are plugged into the correct sockets
The STAND.CONTROL motor controller is ready for operation as soon as the power supply cable
is plugged in!
Note:
Initialisation of the desk base is required the first time the power supply cable is connected
(Reset). This is described in Section 5.
Use only the accompanying mains power cord. The controller STAND.CONTROL C1 mandatorily needs a
2-pole mains cable.
Attention:
Fasten all cables to the desk base or the desktop so they cannot get damaged during
operation.
5.2.4 Installing optional accessories
There is a large number of optional accessories available for the FREE.STAND 9051 table-top support frame
(for example, CPU mounting, cable ducts, screens etc.).
These accessories are to be fitted after installing the actual table-top support frame. With some of the
accessories, it may be necessary to move the table up once, before they can be installed. In such a case,
assemble the table-top support frame as described up to point 5.2.3, and the carry out a reset in accordance
with point 5.
Thereafter, you can move the table to the required height. Isolate the table-top support frame from the mains
again and continue with the installation of the accessories.
Upon completion of the accessories installation, carry out point 5.2.3 and if required, point 5.3 (Reset) once
again.
