![background image](http://html.mh-extra.com/html/omron/zx2-ld100/zx2-ld100_user-manual_1633410099.webp)
Bank Setting
99
ZX2 User’s Manual
INTRODUCTION
BASIC
SETUP
PREPARATION
FOR
MEASUREMENT
TROUBLE-
SHOOTING
INDEX
CONTENTS
SETTING
TRANSITION
CHARTS
FLOW OF
OPERATION
MAIN
APPLICATIONS
& SETTING
METHODS
DETAILED
SETTINGS
SPECIFI-
CATIONS
Height
Double
Sheet
Detection
Positioning
Eccentricity
and Surface
Deflection
Steps
and
Warpage
Thickness
Bank Setting
Bank setting:
Up to four sets of settings can be stored in memory. (Default: bank 0) This is
recommended, for example, when measuring on multi-lot lines.
Procedure for setting up banks
• When connecting two or more Amplifier Units, use the CH1 Amplifier Unit for switching. The
Amplifier Units of CH2 and later are switched together with CH1.
1
Set to the MENU mode
Button
Operation
Display
Description of Operation
Explanation of
Selection Menu
Hold down the
button for
three seconds to switch to the
MENU mode.
Press the button to display
.
* This step is not required if
detail menu display is
already set to ON in the
MENU mode.
Press the button to set the
display to
to set display of
the detail menu.
Press the
button to apply
the setting.
Bank switching
2
Various settings
3
Set to the MENU mode
1
Return to RUN mode
4
Setting completed
Self-trigger level
Display during zero reset
Sensing conditions
when executing smart tuning
The following menu settings can be registered to banks:
Measured value display scaling
Pre-scaling display value 1
Post-scaling display value 1
Pre-scaling display value 2
Post-scaling display value 2
HIGH threshold
LOW threshold
Response time
Hysteresis width
Important
Hold down for
3 seconds
Lit
Press to display
.
Press to display.
Setting channels used when connecting multiple units
Bank switching: CH1
Bank registration: Each CH