Omron WS02-CFSC1-E, Operation Manual

Page: 15 / 87

xvi
Intended Audience 1
1 Intended Audience
This manual is intended for the following personnel, who must also have
knowledge of electrical systems (an electrical engineer or the equivalent).
• Personnel in charge of installing FA systems
• Personnel in charge of designing FA systems
• Personnel in charge of managing FA systems and facilities
• Personnel qualified, authorized, and responsible for maintaining safety in
equipment design, installation, operation, maintenance, and disposal
2 General Precautions
The user must operate the product according to the performance specifica-
tions described in the operation manuals.
Before using the product under conditions which are not described in the
manual or applying the product to nuclear control systems, railroad systems,
aviation systems, vehicles, combustion systems, medical equipment, amuse-
ment machines, safety equipment, and other systems, machines, and equip-
ment that may have a serious influence on lives and property if used
improperly, consult your OMRON representative.
Make sure that the ratings and performance characteristics of the product are
sufficient for the systems, machines, and equipment, and be sure to provide
the systems, machines, and equipment with double safety mechanisms.
This manual provides information for installing and operating the NE1A Logic
Simulator. Be sure to read this manual before attempting to use the Simulator
and keep this manual close at hand for reference during operation.
3 Safety Precautions
!WARNING
The NE1A Logic Simulator simulates the safety logic of an NE1A Controller.
Operation and timing, however, vary somewhat from that of the NE1A Control-
ler. After debugging safety logic on the NE1A Logic Controller, always debug
the safety logic directly on the NE1A Controller to verify operation. Debugging
only on the NE1A Logic Simulator may result in unexpected operation, possi-
bly causing accidents.