135
RFID System
Operation Manual
Se
ct
io
n 5
End Code
s
Section 5
Communications
End Codes
End codes are given by two hexadecimal digits.
Note: Data processing has been normally completed for an error code of 7B. If communications are not
possible because of a low battery, an error response (e.g., with error code 72 will be returned.)
For more details on errors, refer to
.
Type
End code
Name
Normal
00
Normal end code
74
Polling Command received, Polling Command Check (no results)
75
Auto Command canceled before a Data Carrier was detected.
Polling Command canceled before a Data Carrier was detected.
Normal end code for a MANAGEMENT DATA CHECK/CALCULATE command or
MANAGEMENT DATA SUBTRACTION/LIMIT command (not an error)
76
Auto Command canceled after a Data Carrier was detected.
Polling Command canceled after a Data Carrier was detected.
Host communications
errors
10
Parity error
11
Framing error
12
Overrun error
13
FCS error
14
Format error
Execution status error
18
Frame length error
Data Carrier communica-
tions errors
70
Data Carrier communications error
71
Mismatch error
72
Data Carrier missing error
76
Copy error
7A
Address error
7C
Read/Write Head not connected
7D
Write-protected
Data Carrier memory
warnings
7B
Battery low warning (Replace the battery or Data Carrier.) (See note.)
76
Error end code for a MANAGEMENT DATA CHECK/CALCULATE command or
MANAGEMENT DATA SUBTRACTION/LIMIT command (verification error or
overwrite limit exceeded)
System errors
92
Antenna section power supply voltage error
93
Internal memory error
Summary of Contents for V600 Series
Page 50: ...48 Section 2 Wiring RFID System Operation Manual Section 2 Installation and Wiring MEMO ...
Page 72: ...70 Section 4 Write Command Memory RFID System Operation Manual Section 4 Function ...
Page 138: ...136 Section 5 End Codes RFID System Operation Manual Section 5 Communications MEMO ...