90
SECTIO
N
4
Un
ders
ta
nding Set
ting Opera
tions
V530-R160
Operation Manual
SECTION 4
Basic Operations
Save Settings and Exit the V530-R160
Be sure to save the revised setting data to flash memory before turning OFF.
As the V530-R160 loads data from flash memory at startup, any new data will be lost if it is not saved to flash
memory. The stored images cannot be saved to flash memory and are cleared when the power is turned
OFF. The images must be backed up in the computer or the Memory Card if you want to save them long
term.
Refer to page
.
1.
The
MON
(monitor)
mode or
RUN
mode
screen will be displayed.
2.
Move the cursor to
MON
or
RUN
and press
the
ENT
Key.
The mode selections will be displayed.
3.
Select
SAVE
.
.
The confirmation message will be displayed.
4.
Select
Execute
.
Never input the RESET signal or turn OFF
the power while saving or loading. Data
may be lost, and the V530-R160 may not
operate properly the next time it is started.
When saving has been completed, the screen in
1.
will return.
5.
Turn OFF the power supply and exit the V530-R160.
step
5
