Omron SYSMAC-SE2, Practices Manual

Page: 48 / 54

Precautions for Correct Use
To import an NX Unit configuration, you need to set this as follows.
• Set NX Unit numbers so that they do not conflict in the Slave Terminal configuration.
• Set NX Unit numbers so that they are sequential numbers that start from 1.
3-3-4
CJ-series Units
Set the component data for CJ-series Units as follows.
CJ-series Units in a CPU Rack Configuration (Excluding I/O Control
Units)

PLC Box
Set the PLC box as follows.
ID Property name Setting value
20161 Configuration project Same value as "Configuration project" of the CPU Unit
20408 Station ID Same value as "Station ID" of the CPU Unit
20427 Rack ID Blank
20410 PLC card is placed on rack ID Same value as "Rack ID" of the CPU Unit
20411 Position (slot / module) Slot number
20253 1 CPU: Name [1] Same value as "CPU: Name [1]" of the CPU Unit
20418 Version Version (This must be a version that exists in the Sysmac Stu-
dio and a single-byte number that contains periods as the de-
limiter. To specify the version of a Unit whose version is indicat-
ed as "---" on the Sysmac Studio, set "---" or "0.0".)
If blank, the component data will be imported with the latest
version.
Precautions for Correct Use
To import a CJ-series Unit configuration, you need to set this as follows.
• Set slot numbers so that they do not conflict in the CPU Rack configuration.
• Set slot numbers so that they are sequential numbers that start from 0.
• Set slot numbers so that they are not more than the maximum unit number of the CPU Rack
for NJ-series CPU Units.
I/O Control Unit CJ1W-IC101

PLC Box
Leave all the setting values of the PLC box blank.
ID Property name Setting value
20161 Configuration project Blank
20408 Station ID Blank
20427 Rack ID Blank
20410 PLC card is placed on rack ID Blank
20411 Position (slot / module) Blank
3 Setting EPLAN Electric P8
3-12
Sysmac Studio Electrical CAD Connector Function Practices Guide for AutomationML Import (EPLAN Electric P8) (P156)