Omron SYSMAC-SE2, Practices Manual

Page: 39 / 54

3-2 Setting Component Data
This section describes, for each target data, the setting rules for component data in EPLAN Electric
P8, which are necessary for the connector function.
For OMRON devices that support the connector function, EPLAN Data Portal provides component da-
ta that complies with the rules (component data as of June 2022 or later).
3-2-1 CPU Units
Set the component data for CPU Units as follows.

PLC Box
Set the PLC box as follows.
ID Property name Setting value
20416 PLC type designation Model name of the CPU Unit
Example: "NJ101-9000"
20427 Rack ID 0
20167 CPU Selected.
20164 Bus coupler / head station Selected.

Bus Ports (EtherCAT Ports)
Set the PLC connection points of the built-in EtherCAT port as follows.
ID Property name Setting value
20026 Function definition Network / bus cable connection, general
20308 Bus system EtherCAT
20447 Bus interface: Name EtherCAT
20310 Logical network: Bus port is master Selected.
20448 Bus interface: Main bus port Selected.
3-2-2
EtherCAT Slaves
Set the component data for EtherCAT slaves as follows.
EtherCAT Slaves (Excluding Junction Slaves)

PLC Box
Set the PLC box as follows.
ID Property name Setting value
20416 PLC type designation Model name of the EtherCAT slave
Example: "NX-ECC203"
20427 Rack ID 0
20167 CPU Not selected.
20164 Bus coupler / head station Selected.
3 Setting EPLAN Electric P8
3-3
Sysmac Studio Electrical CAD Connector Function Practices Guide for AutomationML Import (EPLAN Electric P8) (P156)
3-2
Setting Component Data
3
3-2-1
CPU Units