Omron Sysmac NX1P2-10 1 Series, User Manual

Page: 403 / 578

11-4 FTP Server Application Example
An example of using the FTP server with the login name "user1" and the password "password" is
shown below.
Additional Information
When a general-purpose FTP application is used, you can use a graphical user interface similar
to Explorer to transfer and read files.

Step
1. Make sure that an SD Memory Card is inserted and turn ON the power supply to the Controller.
2. Connect to the FTP server from a computer on the Ethernet by entering the text that is under-
lined in the following diagram.
Password
(hidden)
Login name
Results
IP address of built-in EtherNet/IP port
C:
\
>ftp 192.168.250.1
Connected to 192.168.250.1.
220 NJ501-1500 FTP
server ready.
User (192.168.250.1: (none)) : user1
331 Password required for user1.
Password:
230 User user1 logged in.
ftp>
ftp> bye
221-
Data traffic for this session was 0 bytes in 0 files.
Total traffic for this session was 204 bytes in 0 transfers.
221 Thank you for using the FTP service on 192.168.250.1.
C: \ >
3. Enter FTP commands (underlined in the following diagram) to read and write files. The following
directory tree is used in this example.
11 FTP Server
11-9
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
11-4 FTP Server Application Example
11