Omron SYSDRIVE 3G3MX-A2002, User Manual

Page: 99 / 254

4-8
4-2 Function Mode
4
Func
tions
RUN Command Selection
Select the method for using the RUN/STOP command.
* To switch to the 2nd RUN command, allocate 08 (SET) to the multi-function input and then turn it on.
Base Frequency
„
Base Frequency and Motor Voltage
Match the Inverter output (frequency/voltage) to the motor rating. Be careful, especially if you set a
base frequency at below 50 Hz. Otherwise, the motor may burn out.
* To switch to the 2nd base frequency, allocate 08 (SET) to the multi-function input and then turn it on.
Data Frequency reference source
00 FREQ adjuster
01 Voltage or current directive from the terminal
02 F001 value set via the Digital Operator
03 ModBus communication
10 Result of the frequency operation function
Parameter No. Function name Data Default setting Unit
A002
RUN command
selection
01: Terminal
02: Digital Operator
03: ModBus communication
02

A202
*2nd RUN command
selection
Related functions F004, A002, C001 to C006
Data RUN command source
01
Turn on/off the FW and RV allocated to the terminal.
The STOP command is activated if both Forward/Reverse commands are input simultaneously.
02 Use the STOP/RESET key on the Digital Operator.
03 Use the ModBus communication.
Parameter No. Function name Data Default setting Unit
A003 Base frequency 30 to Max. frequency [A004]
60.0 Hz
A203 * 2nd base frequency 30 to Max. frequency [A204]
Related functions A004, A204, A081, A082