191
Temperature Input Units
Section 6-4
5. Set the scaling point 0% value and scaling point 100% value.
6. When using an offset compensation, enter the offset value into the
Scaling
Offset
Field.
7. Return to the
General
Tab Page, click the
Download
Button, and then
click the
Reset
Button to reset the Unit.
8. Click the
OK
Button to exit.
Peak/Bottom Hold
The peak/bottom hold function is used to hold the maximum (peak) value or
minimum (bottom) value of the temperature input value. When the Hold Flag
(output) allocated in the Output Area turns ON, the hold function starts,
searching for the peak or bottom value until the Hold Flag turns OFF. (The
peak/bottom value is refreshed when the Hold Flag turns OFF.) The compara-
tor function can be used to compare the peak or bottom values allocated as
temperature data. (Refer to details on the comparator function.)
Summary of Contents for SMARTSLICE GRT1-DRT
