![background image](http://html1.mh-extra.com/html/omron/r88d-kn01h-ect-l/r88d-kn01h-ect-l_user-manual_744172563.webp)
A - 117
Appendices
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
A-3
S
y
smac Error Sta
tus
Cod
es
A
A-3
-2 Error Des
c
ription
Event name
Other Errors
Event code
04B2 0000 hex
Description
The Servo Drive malfunctioned, or an error occurred in the Servo Drive.
Source
EtherCAT Master Function Module
Source
details
Slave
Detection
timing
Continuously
Error
attributes
Level
Minor fault
Recovery
Error reset
(after cycling slave
power)
Log category
System
Effects
User program
Continues.
Operation
Power drive circuit is OFF for relevant slave.
Indicators
EtherNet/IP NET RUN
EtherNet/IP NET ERR
EtherNet/IP LINK/ACT
–
–
–
System
-defined
variables
Variable
Data type
Name
None
–
–
Cause and
correction
Assumed cause
Correction
Prevention
The control circuit malfunctioned
temporarily due to excess noise or
some other problem.
Turn OFF then ON again the
power supply.
Take noise countermeasures.
The self-diagnosis function of the
Servo Drive detected an error in
the Servo Drive.
If the error persists even after
taking the countermeasures
above, replace the Servo Drive.
None
Attached
information
None
Precautions/
Remarks
“99” is displayed on the Servo Drive front panel and F*99 is given as the AlarmCode (4001 hex).
Event name
Safety Input Error
Event code
080B 0000 hex
Description
At least one of the input photocouplers for safety inputs 1 and 2 turned OFF.
Source
EtherCAT Master Function Module
Source
details
Slave
Detection timing
Continuously
Error
attributes
Level
Minor fault
Recovery
Error reset
(after resetting slave
errors)
Log category
System
Effects
User program
Continues.
Operation
Power drive circuit is OFF for relevant slave.
Indicators
EtherNet/IP NET RUN
EtherNet/IP NET ERR
EtherNet/IP LINK/ACT
–
–
–
System
-defined
variables
Variable
Data type
Name
None
–
–
Cause and
correction
Assumed cause
Correction
Prevention
The cable is disconnected or
broken.
Reconnect the input wiring for
safety inputs 1 and 2. If the cable
is broken, replace it.
Reconnect the input wiring for
safety inputs 1 and 2.
Attached
information
None
Precautions/
Remarks
“30” is displayed on the Servo Drive front panel and F030 is given as the AlarmCode (4001 hex).