![background image](http://html1.mh-extra.com/html/omron/r88d-1snx-ect-series/r88d-1snx-ect-series_startup-manual_744171016.webp)
16
3. Performing setup
3.1. Installation & Wiring
■ Drive installation
Install the Servo Drive according to the following.
When installing side-by-side, S2 can be reduced to 0mm under some conditions:
temperature inside cabinet should be lower than 45
℃
and install a fan for air circulation to
prevent uneven temperatures inside the cabinet/panel.
1.
In case of using the shield clamp, please fixe it in advance with the existing screw
Summary of Contents for R88D-1SNx-ECT Series
Page 17: ...17 2 Approach the drive from top to down 3 Tight the upper part 4 Tight the down part...
Page 38: ...38 6 Add the Emergency stop button 7 Add the Reset button 8 Edit I O Map variables...
Page 58: ...58 11 Results Wizard step 5 Save to EEPROM Finish...
Page 59: ...2016 0616 0616 I823 E1 01 Note Do not use this document to operate the Unit...