Omron NX-ILM400, User Manual

Page: 72 / 176

4 Installation and Wiring
4 - 14 NX-series IO-Link Master Unit User’s Manual (W567)
When you use any ferrules other than those in the above table, crimp them to the twisted wires so that
the following processed dimensions are achieved.
 Using Twisted Wires/Solid Wires
If you use twisted wires or solid wires, use the following table to determine the correct wire specifica-
tions.
Terminals Wire type Wire plating
Wire size
Conductor
length (strip-
ping length)
Classifica-
tion
Current
capacity
Twisted
wires
Solid
wire
Plated Unplated
All terminals
except
ground ter-
minals 2 A max. Possible Possible Possible Possible 0.08 to 1.5
mm
2
(AWG
28 to 16)
8 to 10 mm
Greater
than 2 A
and 4 A or
less Possi-
ble
*1
Not possi-
ble
Greater
than 4 A Possi-
ble
*1
*1. Secure the wires to the screwless clamping terminal block. Refer to Securing Wires on page 4-19 for the
procedure to secure the wires.
Not pos-
sible Not pos-
sible
Ground ter-
minals --- Possible Possible Possi-
ble
*2
*2. When you use the NX-TB  1 Terminal Block, use twisted wires to connect the ground terminal. Do not
use solid wires.
Possible
2.0 mm
2
9 to 10 mm
8 to 10 mm
2.4 mm max.
(Terminals other than ground terminals)
2.7 mm max.
(Ground terminals)
1.6 mm max.
(Terminals other than ground terminals)
2.0 mm max.
(Ground terminals)
Conductor length (stripping length)