Omron NJ501-5300, Instruction & Reference Manual, Page: 7 / 142

5
Manual Structure
NJ/NY-series G code Instructions Reference Manual (O031)
Manual Structure
The following page structure and symbols are used in this manual.
Note This illustration is only provided as a sample. It may not literally appear in this manual.
Page Structure and Symbols
4-9
4 Installation and Wiring
NJ-series CPU Unit Hardware User’s Manual (W500)
st
i
n
U
g
ni
t
n
u
o
M
3-
4
4
st
n
e
n
o
p
m
o
C
r
ell
or
t
n
o
C
g
ni
t
c
e
n
n
o
C
1-
3-
4
4-3 Mounting Units
The Units that make up an NJ-series Controller can be connected simply by pressing the Units together
and locking the sliders by moving them toward the back of the Units. The End Cover is connected in the
same way to the Unit on the far right side of the Controller.
1
Join the Units so that the connectors fit exactly.
2
The yellow sliders at the top and bottom of each Unit lock the Units together. Move the sliders
toward the back of the Units as shown below until they click into place.
Precautions for Correct Use Precautions for Correct Use
4-3-1 Connecting Controller Components
Connector
Hook
Hook holes
Slider
Lock
Release
Move the sliders toward the back
until they lock into place.
Level 1 heading
Level 2 heading
Level 3 heading
Level 2 heading
A step in a procedure
Manual name
Special information
Level 3 heading
Page tab
Gives the current
headings.
Indicates a procedure.
Icons indicate
precautions, additional
information, or reference
information.
Gives the number
of the main section.
The sliders on the tops and bottoms of the Power Supply Unit, CPU Unit, I/O Units, Special I/O
Units, and CPU Bus Units must be completely locked (until they click into place) after connecting
the adjacent Unit connectors.