Omron NJ101-10 Series, User Manual

Page: 141 / 280

5-8 Using the Sysmac Studio to Obtain
Serial Numbers from the Actual Net-
work Configuration
If the Serial Number Check Method in the EtherCAT master settings is set to Setting = Actual
device , you must download the network configuration information in which the slave serial numbers
are set to the CPU Unit.
Use the following procedure to get the serial numbers of the physical slaves and apply them as the
serial numbers of the slaves in the settings on the Sysmac Studio.
1
Start the Sysmac Studio and go online with the Controller.
2
Double-click EtherCAT under Configurations and Setup on the Multiview Explorer. Or, right-
click EtherCAT under Configurations and Setup and select Edit .
3
Right-click the EtherCAT master that is displayed in the EtherCAT Tab Page and select Get
Slave Serial Numbers .
The serial numbers of the physical slaves are saved as the serial numbers in the slave settings
on the Sysmac Studio.
5 Setting Up EtherCAT Communications with the Sysmac Studio
5-43
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
5-8 Using the Sysmac Studio to Obtain Serial Numbers from the Actual Network
Configuration
5