The EtherCAT slave settings are listed below.
Name
Edit-
ing
Remarks
Device name
OK
Displays the name of the slave.
Default setting: E*** (where * is a serial number starting from 001)
The default value is automatically generated based on the node ad-
dress.
Model name
Not
al-
lowed.
Automatically displays the name of the slave model.
Product name
Not
al-
lowed.
Displays the product name of the slave.
Revision
Not
al-
lowed.
Displays the revision of the slave.
PDO Communications Cycle
Not
al-
lowed.
Displays the process data communications cycle assigned for the
slave.
Either of the following values is displayed.
•
PDO Communications Cycle 1
Communications cycle is the task period of the primary periodic
task.
•
PDO Communications Cycle 2
Communications cycle is the task period of the priority-5 periodic
task.
Node Address
OK
Sets the node address.
The default value is set automatically when a slave is added.
Setting range: Settable node address range
5 Setting Up EtherCAT Communications with the Sysmac Studio
5-21
NJ/NX-series CPU Unit Built-in EtherCAT Port User's Manual (W505)
5-5 EtherCA
T Slave Parameter Settings
5
5-5-1
Changing the PDO Map Settings
Summary of Contents for NJ101-10 Series
