Omron NE1A-EDR01, Operation Manual

Page: 36 / 109

19
Connecting to Ethernet (EtherNet/IP) Section 2-4
2-4-2 TCP/IP Configuration
This section describes the TCP/IP-related settings, such as the ED Router
local IP address and subnet mask. Use the Network Configurator to make
these settings. The settings are stored in the ED Router non-volatile memory.
Note (1) With the default settings, the IP address will be 192.168.250.1 if 00 or FF
is set.
(2) If the IP address switch is set to a value other than 00 or FF, the switch
setting will be used for the rightmost bit of the IP address. To use the val-
ue set from the Network Configurator, set the IP address switch to 00 or
FF.
(3) To use the BOOTP server, set the IP address switch to 00 or FF.
Making TCP/IP
Settings with the
Network Configurator
1,2,3... 1. Select Programs - OMRON Network Configurator for DeviceNet Safety
- Network Configurator from the Start Menu. The Network Configurator
will be started.
2. Connect the Network Configurator online. (First set the interface with Op-
tion - Select Interface , and then select Network - Connect .)
3. Select EtherNet/IP in the Network Configuration Window. (For example,
click the
EtherNet/IP Tab.)
4. Select Tools - Setup TCP/IP Configuration . The Setup TCP/IP Configu-
ration Dialog Box will be displayed.
The settings are all at their default values.