Chapter 10: Maintenance
Figure 10-19. LD Drive Assembly (arrow)
6. Lift the drive wheel up, compressing its springs, enough so that you can insert a Ø6 x
10 mm (0.24 x 0.4 inch) pin into the hole on the rear side of the assembly (there is a
hole on each side). This will keep the springs compressed (the wheel will be in the up
position), and make removal easier. An M5 x 10 screw works well for this. If you saved
the wheel pin, it should be used for this. See Figure 3-9. See also
Figure 10-20. Spring-Compression Hole (arrow)
7. The drive assembly is held in place with three nuts on studs across the top, and two
pairs of screws at each side, near the bottom of the assembly.
Remove the three nuts and four screws (and their washers) holding the drive assembly
to the platform.
Retain these nuts, screws, and washers for attaching the new drive assembly.
14766-000 Rev H
LD Cart Transporter User's Manual
175
