0BPreparation
2-8
Preparation
●
Connector
This connector is used to connect units to each other.
Inter-unit communication can be carried out to expand functions.
x
Installation
procedure
Lift the cover on top of the product and set the connection connector. Close the
cover before use.
x
Removal
procedure
Open the lid at the top of the product, and remove the connection connector by
hooking a flat head screwdriver on the red circle portion shown in the figure.
* Be careful not to make the flat head screwdriver contact the internal board.
* 1 When multiple units are used within the system, be sure to install the connector by
locking it with the horizontal connecting hook.
